VS Arduino
>> >> Uploading to Aruduino Micro 32u4
https://www.visualmicro.com/forums/YaBB.pl?num=1497414099

Message started by thinwingflyer on Jun 14th, 2017 at 4:21am

Title: Uploading to Aruduino Micro 32u4
Post by thinwingflyer on Jun 14th, 2017 at 4:21am
Uploading to this board bricks it everytime.  It's destroyed 4 different boards and the bootloader trick by hitting the reset button doesn't fix it.  Is this a known bug??  The Arduino IDE does works fine, but using Visual Micro with Visual Studio 15 kills these boards.

Title: Re: Uploading to Aruduino Micro 32u4
Post by Visual Micro on Jun 14th, 2017 at 9:51am
No not a known bug. You can use an Uno or other board as ISP and re-burn the bootloaders

Switch on "vMicro>Compiler>Verbose" and "vMicro>Compiler>Show Build Properties" then build and post the output at .txt thenw e can see which board and what is installed

What is the program size after build?

Thanks






Title: Re: Uploading to Aruduino Micro 32u4
Post by Visual Micro on Jun 26th, 2017 at 12:30pm
Sorry for the delay.

Investigation showed that the "program too large warning" that prevents upload of arduino programs that are too large was missing from the last few versions of visual micro. This is resolved in the latest release due to be published over the next 24 hours.


I assume you were building with visual micro in debug mode. That is the only way your program size could be larger than that produced by the arduino ide hence the difference between the two upload processes.

So thanks for the report and if you email info@visualmicro.com with a link to this post I will provide you with free licences for visual micro pro.

Thanks for the report and sorry for the confusion.


VS Arduino » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.