VS Arduino | |
>> >> In VS 2008 intellisense stops working when I change board
https://www.visualmicro.com/forums/YaBB.pl?num=1318797075 Message started by Visual Micro on Oct 16th, 2011 at 8:31pm |
Title: In VS 2008 intellisense stops working when I change board Post by Visual Micro on Oct 16th, 2011 at 8:31pm
If intellisense suddenly stops working in an arduino project then close the project and delete the .ncb file from the sketch/project folder.
The most obvious sign of intellisense failing is switching between uno and mega boards. CTRL+J should show one "Serial" entry for the uno and "Serial, Serial 1, Serial 2 etc" when you select a mega board This is a known Visual Studio 2008 problem and is not caused by the addin |
VS Arduino » Powered by YaBB 2.6.12! YaBB Forum Software © 2000-2024. All Rights Reserved. |