Visual Studio Ide for Arduino
https://www.visualmicro.com/forums/YaBB.pl
Other >> Arduino for Visual Studio 2010 >> Programming and debugging 2 boards
https://www.visualmicro.com/forums/YaBB.pl?num=1426625117

Message started by JohnW on Mar 17th, 2015 at 8:45pm

Title: Programming and debugging 2 boards
Post by JohnW on Mar 17th, 2015 at 8:45pm
Hi, Think I posted this in the wrong section so moved here.....
New to MS Visual Studio and Visual Micro this but loving them so far. Can I use 2 Arduinos and debug them? I want to play with a couple of wireless modules so need to program and debug 2 boards. This page suggests this is possible http://www.visualmicro.com/page/User-Guide.aspx?doc=Projects-and-Solutions.html
I have managed to program 2 boards to write a counter to the serial port as a test (Not totally sure how) and monitor both on different com ports but can't control the debugger. All a bit confused to be honest.
Any help appreciated
Thx

Title: Re: Programming and debugging 2 boards
Post by Visual Micro on Mar 18th, 2015 at 1:56pm
Hi John,

You can only debug one board at a time in a Visual Studio instance so you need to open up two copies of Visual Studio one for each project. Then you will get a clean debug session for each.

If you have not debugged before you should debug the blink sketch or something simple first

Thanks

Visual Studio Ide for Arduino » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2019. All Rights Reserved.