VS Arduino
Visual Micro >> Other Hardware >> Arduino code via ATMEL ICE over JTAG too complicated ...
https://www.visualmicro.com/forums/YaBB.pl?num=1433320006

Message started by Schlueri on Jun 3rd, 2015 at 8:26am

Title: Arduino code via ATMEL ICE over JTAG too complicated ...
Post by Schlueri on Jun 3rd, 2015 at 8:26am
Hi all !
I have some SODAQ boards connected to ATMEL Studio + VM (latest rev.) In the Arduino IDE all is working fine but the board is not recognized in the VM environment ... so i tried an ATMEL ICE this is working but there is no automatic built process possible ... i have to perform many clicks to program the target "manually"  :( does somebody have an idea to get a connection from the autobuilder to a JTAG connected target ?
Thank you in advance !

Title: Re: Arduino code via ATMEL ICE over JTAG too complicated ...
Post by Visual Micro on Jun 3rd, 2015 at 8:28am
What do you mean the board is not recognized

VS Arduino » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.