VS Arduino
Visual Micro >> General Board >> lock bits setting for Arduino with visual micro
https://www.visualmicro.com/forums/YaBB.pl?num=1520714394

Message started by marc_friedheim on Mar 10th, 2018 at 8:39pm

Title: lock bits setting for Arduino with visual micro
Post by marc_friedheim on Mar 10th, 2018 at 8:39pm
Hello, I would like to know if lock-bits can be set in visual micro with an external programmer? Does anyone know this?

Title: Re: lock bits setting for Arduino with visual micro
Post by Visual Micro on Mar 11th, 2018 at 2:00pm
some points that might help...

when you burnbootloader lock bits are set.

the programmer system allows you to add your own programmers

visual micro does support arduino pre and post upload events

visual micro in atmel studio allows atmel device programming to be used.

Title: Re: lock bits setting for Arduino with visual micro
Post by marc_friedheim on Mar 11th, 2018 at 2:42pm
Thanks Tim. Yes so I know in Atmel Studio I can manipulate lockbits, don't know if visual studio combined with visual micro can do this? Does anyone from the forum knows this?

Title: Re: lock bits setting for Arduino with visual micro
Post by Visual Micro on Mar 12th, 2018 at 7:26pm

the programmer system allows you to add your own programmers

visual micro does support arduino pre and post upload events

VS Arduino » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.