Visual Studio Ide for Arduino
https://www.visualmicro.com/forums/YaBB.pl
Visual Micro >> General Board >> Issue with Pololu 32U4 software
https://www.visualmicro.com/forums/YaBB.pl?num=1539863590

Message started by Harrzack on Oct 18th, 2018 at 12:53pm

Title: Issue with Pololu 32U4 software
Post by Harrzack on Oct 18th, 2018 at 12:53pm
Greets!   This is just an FYI for Tim.   I've started using the Pololu A-Star U32 series micro's which, with their extra library works well with Arduino iDE and VS.  However - if I have a sketch where VM debug is NOT enabled - I get the below message, and when I enable debug, it goes away.   HTH!

=Alan R.
---------------------------------
[code]Compiling 'ConstantSpeed-avr' for 'Pololu A-Star 32U4'
Program size: 8,224 bytes (used 29% of a 28,672 byte maximum) (0.85 secs)
Minimum Memory Usage: 447 bytes (17% of a 2560 byte maximum)

Uploading 'ConstantSpeed-avr' to 'Pololu A-Star 32U4' using 'COM10'
     The upload process has finished. via 'COM11'
Connecting to programmer: .
Found programmer: Id = "CATERIN"; type = S
    Software Version = 1.0; No Hardware Version given.
Programmer supports auto addr increment.
Programmer supports buffered memory access with buffersize=128 bytes.
Programmer supports the following devices:
    Device code: 0x44
[/code]

Visual Studio Ide for Arduino » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2019. All Rights Reserved.