VS Arduino | |
Visual Micro >> Hardware Debugging (GDB, GDB WiFi, GDB Stub) >> BMP Debugger with all arm chips
https://www.visualmicro.com/forums/YaBB.pl?num=1565789145 Message started by Natsuki-chan on Aug 14th, 2019 at 1:25pm |
Title: BMP Debugger with all arm chips Post by Natsuki-chan on Aug 14th, 2019 at 1:25pm
After using the black magic probe debugging in visual micro itself I cannot turn back again to my own solution.
I have been using it for STM32F103 boards but I cannot use it for other ARM devices like the Arduino Due. How can I easily configure it for other boards that do not have the black magic probe option? |
Title: Re: BMP Debugger with all arm chips Post by Simon Hopkinson on Aug 15th, 2019 at 2:37pm
There will be a release next week which will contain the pre-configured Black Magic Probe for the SAM Boards such as the DUE.
To custom configure any debugger you can follow this guide, but please pay attention to the notes/warnings... https://www.visualmicro.com/page/Debugging-Using-Custom-Hardware.aspx |
Title: Re: BMP Debugger with all arm chips Post by Simon Hopkinson on Aug 18th, 2019 at 10:57pm
The latest update on the below (1908.18) contains the Black Magic pre-configured for debugging the DUE. It is not setup for upload at present, only for debug.
https://www.visualmicro.com/forums/YaBB.pl?board=VS_ARDUINO_EXT_RELEASES Further information can be found on this page: https://www.visualmicro.com/page/SAM-Debugging.aspx |
VS Arduino » Powered by YaBB 2.6.12! YaBB Forum Software © 2000-2024. All Rights Reserved. |