VS Arduino | |
Visual Micro >> Project Guidance >> My code is without error but doesn't work!!!
https://www.visualmicro.com/forums/YaBB.pl?num=1585924911 Message started by BeagleBot on Apr 3rd, 2020 at 2:41pm |
Title: My code is without error but doesn't work!!! Post by BeagleBot on Apr 3rd, 2020 at 2:41pm
Hello, all.
I have a code that works with three device an SH1106 Oled An BME280 and an SKYLAB SK53 serial GPS. When I disable the code of the BME280 in my code then the GPS and display works fine. When I make a separate code for the BME280 this works also fine with the display. But the same in one code noting on the display. https://www.visualmicro.com/forums/YaBB.pl?action=downloadfile;file=Travel_Clock.zip ( 1 KB | 9
Downloads )
|
Title: Re: My code is without error but doesn't work!!! Post by Visual Micro on Apr 3rd, 2020 at 4:09pm
Please post code as zip, thanks
|
Title: Re: My code is without error but doesn't work!!! Post by BeagleBot on Apr 4th, 2020 at 7:56am
OK, zipt the file....
|
Title: Re: My code is without error but doesn't work!!! Post by Visual Micro on Apr 4th, 2020 at 11:33am
Can you confirm the toolbar is set to Release and not Debug?
Can you confirm your code works when uploaded with Arduino? |
VS Arduino » Powered by YaBB 2.6.12! YaBB Forum Software © 2000-2024. All Rights Reserved. |