VS Arduino | |
>> >> Visual Studio Crashes when trying to change a breakpoint
https://www.visualmicro.com/forums/YaBB.pl?num=1598444865 Message started by Jonas98 on Aug 26th, 2020 at 12:27pm |
Title: Visual Studio Crashes when trying to change a breakpoint Post by Jonas98 on Aug 26th, 2020 at 12:27pm
Hello,
today Ive installed Visual Studio and Visual Micro. My intention is to get betetr debug functionalitys than the Arduino IDE. So i tried this wirth the Arduino blink example. Createt an Breakpoint with an "Actions". Startet/uploaded the Sketch. Worked fine... But when I try to change something at the Actions of the breakpoint Visual Studio Crashes and restart. The Crash happen when i click the marked part of the picture. Thank you for your help. Because the funktionality of visual micro is very nice. But an crash every time I try to change something is annoying... |
Title: Re: Visual Studio Crashes when trying to change a breakpoint Post by Visual Micro on Aug 26th, 2020 at 3:53pm
Hi
Visual Micro does not have any control or run any code when working with break points. This is 100% visual studio c++. I recommend ensuring your Visual Studio has all updates applied and if that has been done then running a Visual Studio repair. If the problem persists then please use the buttons on help>about to post the list of extensions that you currently have installed in the IDE. Thanks |
VS Arduino » Powered by YaBB 2.6.12! YaBB Forum Software © 2000-2024. All Rights Reserved. |