VS Arduino | |
Visual Micro >> Ideas, Suggestions and Related Tools >> Iar compiler?
https://www.visualmicro.com/forums/YaBB.pl?num=1601557834 Message started by perigalacticon on Oct 1st, 2020 at 1:10pm |
Title: Iar compiler? Post by perigalacticon on Oct 1st, 2020 at 1:10pm
I am in the process of branching out from basic Arduino where I started, and I have been learning-by-doing through a fairly involved project using the AVR ATTiny841 uC. In particular I found that IAR claims to have a significantly reduced size for the hex file and I have run out of space on the ATTiny841 and the chip cannot be changed.
Is it possible to have VM use the IAR compiler to compile the sketch? I have developed everything using the Arduino framework, but I like VM, and would like to try to use IAR compiler if possible to reduce the sketch size. Please excuse my ignorance I am merely a hobbyist new to embedded system development. |
Title: Re: Iar compiler? Post by Visual Micro on Oct 1st, 2020 at 5:42pm
There are a lot of factors that can affect build size. Please post the information requested in yellow above so that we can see your base setup.
Thanks |
VS Arduino » Powered by YaBB 2.6.12! YaBB Forum Software © 2000-2024. All Rights Reserved. |