VS Arduino - Print Page

VS Arduino
Visual Micro >> Usb/Serial/WiFi Debugging >> WiFi debug and OTA Updates not working on MKR WiFi 1010 https://www.visualmicro.com/forums/YaBB.pl?num=1662240931 Message started by PavlosA on Sep 3^rd, 2022 at 9:35pm

Title: WiFi debug and OTA Updates not working on MKR WiFi 1010
Post by PavlosA on Sep 3^rd, 2022 at 9:35pm

Hi - I'm using Arduino 2 and VS community 2022. I can't make OTA Updates or WiFi debug work, even with the supplied example in the video (for the MKR WiFi 1010). I have no problem over USB.

The setup seems simple enough, just changing the Remote Transport to UDP and the local port to the correct IP. I tried changing the Upload Port/IP to the IP address also.

Is this board supported at this point, with these versions? Or is OTA still only for the ESP32 boards?

thanks

Title: Re: WiFi debug and OTA Updates not working on MKR WiFi 1010
Post by Simon@Visual Micro on Sep 5^th, 2022 at 9:35am

Thanks for the report, the Debug:Serial option should be supported by this board for debugging over Wifi.

Can you attach the full build log from your project, with the verbose settings enabled as shown at the top of the page so we can investigate further?

Title: Re: WiFi debug and OTA Updates not working on MKR WiFi 1010
Post by Tim@Visual Micro on Sep 5^th, 2022 at 8:20pm

Thanks for confirming this is an upload issue and not a debug issue.

Can you confirm if OTA upload is working okay in Release mode?

Does OTA upload work in the Arduino IDE?

If the answer is No to both then does the upload work over serial?