Welcome, Guest. Please Login or Register
Arduino IDE for Visual Studio
When Logging a Support Issue in the Forum, please ensure you have also:-
  • Enabled vMicro > Compiler > Show Build Properties and Verbose
  • Re-Compile your program with these settings enabled
Save the new Output to a Text File and....
Support requests without the output above may be impossible to answer, so please help us to help you
  HomeSearch Tutorials & Wiki visualmicro.com LoginHelpRegister  
Page Index Toggle Pages: 1
Send Topic Print
debugging using gdb on windows (Read 736 times)

Posts: 2
debugging using gdb on windows
Aug 8th, 2018 at 3:15pm

I am trying to debug using gdb on windows without any luck so far. I am compiling the program with 'pgcc -g hello.c -o hello' and starts the session with 'gdb hello'. Gdb loads ok, but reports that no debugging symbols is found. I have tried this with pgi version 10.5 and 10.6 (gdb version 6.8 and 7.1), but same same. Have I forgotten something here? I thought gdb format is supported?
I have set up my editor, Slickedit, to compile/build using the pgi compiler. Slickedit also support debugging via gdb, and hence it would be neat to get this working.

Any ideas?

Any help will be apprecited.

I didn't find the right solution from the Internet.

Talent Acquisition Example

Thank you.
Back to top
IP Logged
Simon Hopkinson

Posts: 186
Re: debugging using gdb on windows
Reply #1 - Aug 21st, 2019 at 11:48am
vMicro now supports a range of additional hardware debuggers which should allow this to be done with a few clicks:

Debugger List: https://www.visualmicro.com/page/DebuggerSupportList.aspx
Back to top
IP Logged
Page Index Toggle Pages: 1
Send Topic Print