Welcome, Guest. Please Login or Register
Arduino IDE for Visual Studio
 
 
When Logging a Support Issue in the Forum, please ensure you have also:-
  • Enabled vMicro > Compiler > Show Build Properties and Verbose
  • Re-Compile your program with these settings enabled
 
Save the new Output to a Text File and....
Support requests without the output above may be impossible to answer, so please help us to help you
 
  HomeSearch Tutorials & Wiki visualmicro.com LoginHelpRegister  
 
Page Index Toggle Pages: 1
Send Topic Print
WeMos D1 R1 not setting programmer (Read 123 times)
Bazinoz
Newbies
*
Offline



Posts: 2
WeMos D1 R1 not setting programmer
May 3rd, 2019 at 3:54am
 
When I create a sketch using the Arduino IDE and install the 'WeMos D1 R1' wifi board it sets the Programmer to 'AVR ISP' but the Visual Micro Programmer is blank and can not be selected.
When I try and compile it fails with the error:
"Error creating .hex"
This same sketch uploads and runs fine with the Arduino IDE.

Any idea on how to fix this? Undecided
Back to top
 
 
IP Logged
 
Visual Micro
Administrator
*****
Offline



Posts: 10138
United Kingdom
Re: WeMos D1 R1 not setting programmer
Reply #1 - May 3rd, 2019 at 2:54pm
 
Don't be confused by the arduino ide. It shows a programmer but does not use it unless you click "Upload using programmer"

You have an unrelated build error. Please follow the instructions at the top of this forum to show us your error detail and config.

+ You also have not said if a debug or release build. Testing should be in Release.
Back to top
« Last Edit: May 3rd, 2019 at 2:55pm by Visual Micro »  
WWW  
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print