Hello,

I'm, trying to compile grbl 1.1f with VisualMicro and VS2015 (https://github.com/gnea/grbl/wiki) but it is not possible, i can do it with Arduino 1.8.1 IDE with no problems.

I'm using the example grblUpload and the error i'm getting is:

Error compiling for board Arduino/Genuino Uno
Debug build failed for project 'grbl_1_1f_vs'

wiring.c.o (symbol from plugin)*: In function __vector_16
(.text+0x0)*: multiple definition of __vector_16
stepper.c.o (symbol from plugin)*: (.text+0x0): first defined here

collect2.exe*: error: ld returned 1 exit status
 

Thanks for your help!

Hello!
I have the same problem. 
Yes, in Release Version verything works fine, but I want to debugg the Code.
I found, that there is a Problem with Timer0 that is used in my Code und in the wiring.h file.

I've looked at this and based on your report I think it is safe to assume that the normal arduino serial commands can not be used.

However, you should be able to use the SoftwareSerial option for Visual Micro debug. SoftwareSerial uses PinChange interrupts so should not be affected by timer1. This assumes you have one or two spare digital pins and some memory.

1) Make sure you switch on "vMicro>Debugger>Full Speed Debugging". GRBL seems to be very time critical so you want the debugger causing as little interruption as possible. Which projects that are time critical you will have to be careful about what debug features you use. For example the digital and analog pin viewers read the pins which can take some millis

2) Use the visual micro debugging with other ports and pins document that explains how to configure software serial. 

In essence you tell visual micro to use SoftwareSerial and the Tx and Rx pins. If you only have debug trace messages and watch expressions then you only need the rx pin, if you want break and variables update during debug you also need to set the tx pin.

Hi, sorry for the delay i've been out for a while    

I tried in release mode a it compile well, thanks very much is all i need!