VS Arduino - Can't change upload port

May 5^th, 2025 at 11:47pm (UTC)

Before logging an issue, please update to the latest release of Visual Micro from the Downloads Page.

When Logging a Support Issue in the Forum, please ensure you have also:-

Save the new Output to a Text File and....

Support requests without the output above may be impossible to answer, so please help us to help you

‹ Previous Topic | Next Topic ›

Pages: 1

Can't change upload port (Read 1205 times)

Harrzack Member Offline Posts: 133 Location: Lindenwold, NJ USA Joined: Dec 28^th, 2012	Can't change upload port Oct 30^th, 2018 at 6:18pm	Print Post
	I've managed to hose up the upload port. It is supposed to be COM10 - and now seems to be stuck on COM7. I MAY have caused this - thought I could set the output from Serial to another port so i could upload AND see output on a terminal - NOT! Not VM (VS 2017) will not accept any port change. The desired one is shown - just can't get COM10 to 'stick'. =Alan R.


	IP Logged

Tim@Visual Micro Administrator Offline Posts: 12187 Location: United Kingdom Joined: Apr 10^th, 2010	Re: Can't change upload port Reply #1 - Oct 30^th, 2018 at 6:30pm	Print Post
	Make sure "vmicro>upload>auto select board port" if off It will always help if you state if debug or release mode is selected. also to confirm what settings you have enabled via the vmicro menus.


	WWW Facebook Twitter YouTube IP Logged

Harrzack Member Offline Posts: 133 Location: Lindenwold, NJ USA Joined: Dec 28^th, 2012	Re: Can't change upload port Reply #2 - Oct 30^th, 2018 at 10:42pm	Print Post
	Tim - I was mucking around with settings I didnt realy know about. It was the "Auto select" causing the lock. Tim@Visual Micro wrote on Oct 30^th, 2018 at 6:30pm: Make sure "vmicro>upload>auto select board port" if off It will always help if you state if debug or release mode is selected. also to confirm what settings you have enabled via the vmicro menus.


	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›