When you ask questions please give information about your hardware and IDE version or follow the yellow guide at the top of this page to give us the information we require.

There is 1) Upload and 2) Debug.

1)
The programmers list, for upload, works same as Arduino IDE. If your programmer is not listed then give us the info we need and we will try to add it to the next release.

2)
Use the vMicro>Debugger menu or the "Micro Debug Options" tool bar to select your debugger.

With that configuration the download will be serial/usb and the debug will be ICE

It's important that you follow the yellow guide at the top of this page to show us what you have configured and what you are clicking when you attempt to debug.

You need to have the upload working before you focus on debug.

These things are different for many boards so you really need to give us the information to allow us to help you.

If I assume you are using an Arduino board such as AVR or SAM, have you previously uploaded to your board using the ICE in Atmel Studio or other IDE? If so then the Serial uploader will have been destroyed. In this case you will need to be setting the vMicro>Uploader>Programmer to ICE but maybe it is not provided by Arduino. In which case we will add it but you need to give us the information first.

AS7 is still installed, I need to uninstall it?

No, it's fine to use atmel studio if that is your choice of ide. Atmel can screw with your usb drivers but that's okay if you use atmel.

However you need to be very clear about if you are asking your questions for assistance in atmel studio or visual studio?

For the Due you might as well use atmel now that it is installed. In which case follow the guide in red on our atmel page to set atmel studio device programming as your vMicro>uploader>programmer and atmel studio debugging as your vMicro>debugger

Okay so submit the requested information after build so we can see your settings.

Micro Build

Compiling 'ArduinoDueProject' for 'Arduino Due (Native USB Port)'
Program size: 42.592 bytes (used 8% of a 524.288 byte maximum) (0,56 secs)

Sorry it's first time that request support. I will send you email as request on your yellow box.

You have to click the Reply button to add a file, you can't use the quick reply on the bottom of this page.

I have received the information from you by email although you did not follow the instruction to enable "show build properties" or "verbose".

However, the information does show an upload issue and I suspect it is because atmel destroyed the serial bootloader when you upload using ICE. You will need to reburn the bootloader or wait until next week when we will add an ICE uploader for the SAM boards.

Compiling 'ArduinoDueProject' for 'Arduino Due (Native USB Port)'


ArduinoDueProject.ino:17: In file included from

FastLED.h:14: note  #pragma message  FastLED version 3.002.010

   #    pragma message "FastLED version 3.002.010"

Program size: 42.592 bytes (used 8% of a 524.288 byte maximum) (9,95 secs)


Uploading 'ArduinoDueProject' to 'Arduino Due (Native USB Port)' using 'COM6'

Unable to 'touch' hardware serial port: COM6. Now assuming selected port is bootloader port. This might still fail, have you got the correct board selected?

The uploader process failed

No device found on COM6


 

Can you inform me when this fixing is ready?

ok thanks