May 17th, 2025 at 7:22am (UTC)
 
 

Before logging an issue, please update to the latest release of Visual Micro from the Downloads Page.

When Logging a Support Issue in the Forum, please ensure you have also:-

  • Enabled vMicro > Compiler > Show Build Properties
  • Re-Compile your program with these settings enabled
  		Save the new Output to a Text File and....
  • Click the Reply button and attach as .txt file OR
  • Click here to Email us with the file attached, and a link to your post
Support requests without the output above may be impossible to answer, so please help us to help you
 
  VS Arduino › › › ESP32 upload fails with A fatal error occurred: Failed to connect to ESP32: Timed out waiting for pa
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic ESP32 upload fails with A fatal error occurred: Failed to connect to ESP32: Timed out waiting for pa (Read 1152 times)
FrankP
Senior Member
****
Offline


Posts: 251
Joined: Oct 19th, 2011
ESP32 upload fails with A fatal error occurred: Failed to connect to ESP32: Timed out waiting for pa
Dec 7th, 2023 at 8:07pm
Print Post  
I recently started working with ESP32, but am having problems with 'blink' program.  I can upload fine as long as nothing is connected to GPIO pins.  Otherwise I get the dreaded 


A fatal error occurred: Failed to connect to ESP32: Timed out waiting for packet header

message.  I have googled this and found numerous 'solutions', none of which worked for me. I did find there might be an issue with compile options for the ESP32 Wrover module, so I looked in vMicro options for this.   

I reduced upload speed to 115200, but this had no effect.  I'm not sure what the other options relate to, so I'm a bit reluctant to start changing them.  Has anyone else gotten this module upload reliably?

TIA,

Frank
  
Back to top
 
IP Logged
 
FrankP
Senior Member
****
Offline


Posts: 251
Joined: Oct 19th, 2011
Re: ESP32 upload fails with A fatal error occurred: Failed to connect to ESP32: Timed out waiting for pa
Reply #1 - Dec 8th, 2023 at 2:49am
Print Post  
Well, for some reason this is now working fine. I can upload programs to the ESP32 even with the same circuit connection as before (a 240-Ohm resistor and an LED in series).

No clue what I did (or didn't) do to make this work, other than the fact that I uploaded several programs with nothing connected, and then discovered it was still working with the LED/resistor circuit connected.

I have a PhD in electrical engineering and I'm stumped by the simplest of projects - Go figure.   Grin
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

VS Arduino » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.