May 2nd, 2025 at 6:50pm (UTC)
 
 

Before logging an issue, please update to the latest release of Visual Micro from the Downloads Page.

When Logging a Support Issue in the Forum, please ensure you have also:-

  • Enabled vMicro > Compiler > Show Build Properties
  • Re-Compile your program with these settings enabled
  		Save the new Output to a Text File and....
  • Click the Reply button and attach as .txt file OR
  • Click here to Email us with the file attached, and a link to your post
Support requests without the output above may be impossible to answer, so please help us to help you
 
  VS Arduino › › › BootUp time different using VisualMicro or Arduino
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic BootUp time different using VisualMicro or Arduino (Read 786 times)
JoeLeTurbo
Newbies
*
Offline


Posts: 2
Joined: Jan 13th, 2021
BootUp time different using VisualMicro or Arduino
Jan 13th, 2021 at 3:41pm
Print Post  
Hello,

I have some problems with the BootUp time with my Teensy 3.2

Here is my test sketch:
Code
Select All
uint32_t Test;

void setup() {
	Test = millis();

	Serial.begin(115200);
	while (!Serial);
}

void loop() {
 
	delay(10000);                       // wait for 10 seconds
	Serial.println();
	Serial.print("BootTime: ");
	Serial.print(Test);
 Serial.print(" ms");
}


If I compile (Release mode) and upload it with VisualMicro I get a BootUp time of arround 4310 ms.
If i compile the same code in Arduino I get a boot up time of 300ms.

Where is the difference and how can I get the same BootTime?

I'm using VS2019 and VisualMicro V 2020.910.8

JoeLeTurbo
« Last Edit: Jan 13th, 2021 at 3:42pm by JoeLeTurbo »  
Back to top
 
IP Logged
 
Simon@Visual Micro
Administrator
*****
Offline


Posts: 2695
Joined: Feb 13th, 2019
Re: BootUp time different using VisualMicro or Arduino
Reply #1 - Jan 13th, 2021 at 3:48pm
Print Post  
Can you confirm you have the same board options set in both IDE's when comparing them?
(USB Type / CPU Speed / Optimize)

If they are the same please upload the full Build Output from both IDE's, with the below options set:
1) Visual Micro: Enable options > vMicro > Compiler > Show Build Properties and Verbose
2) Arduino IDE: Preferences > Show Verbose Output During Compilation [ticked]
  
Back to top
WWWFacebookTwitterYouTube  
IP Logged
 
JoeLeTurbo
Newbies
*
Offline


Posts: 2
Joined: Jan 13th, 2021
Re: BootUp time different using VisualMicro or Arduino
Reply #2 - Jan 15th, 2021 at 8:34pm
Print Post  
Yes, the board options were the same.

I reinstalled VisualMicro and now it works perfectly.
I now get the same boot up time in release version.
The debug version still takes 4310 ms but I think that is ok because of debug.

Thank you
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

VS Arduino » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.