I'm trying to use Visual Micro with J-Link on a Seeeduino Xiao.  I am able to program the board but the debugger won't start.  
I followed the steps in the Visual Micro Hardware Debugging video.  One thing I did that was not according to the video was that my J-Link was on USB Interface 3, not 0, so I intalled WinUSB to  J-Link on Interface 3. 

When I run Debug/Start Debugging it loads the firmware to the board and the LED flashes as it should, but I get the error:

Starting: "C:\ProgramData\vmicro\tools\openocd-0.10.0.20200213\bin/openocd.exe" -d2 -l g/Blink1.ino_DebugOpenOCD.log}" -s "C:\ProgramData\vmicro\tools\openocd-0.10.0.20200213/scripts/" -f "interface/jlink.cfg" -c "transport select swd" -f ariants/XIAO_m0/openocd_scripts/XIAO_m0.cfg" -c "init; reset halt"
Starting: cc\7-2017q4/bin\arm-none-eabi-gdb.exe" --interpreter=mi
"C:\ProgramData\vmicro\tools\openocd-0.10.0.20200213\bin/openocd.exe" exited with code 1 (0x1).

I have double checked my connections from the board to the J-Link and the J-Link LED is green.

Attached is a screenshot of my Visual Studio window showing the settings, the program with breakpoints set and the output.

What could the problem be?

Also, one other question:  When hardware debugging does Visual Micro upload the firmware using the board's USB serial connection or does it upload with the hardware debugger?  I need to upload with the hardware debugger because I'm developing an Arduino based USB OTG host, so the Arduino USB port would not be available after the firmware is loaded.